Comments from a previous post led me here.
I’ve brewed maybe six or seven batches… oh maybe even ten, at my new house. Different city, different water supply. All the same equipment, same sanitization and inspection procedures to make sure I’m not introducing contaminants.
My issue is twofold. First I’m not getting quite the nice distinct flavors that I used to at the old house. The beers seemed to be sharper with more clarity of taste where the batches here seem muddled, if that makes sense. Even the IPA and Pale Ale have come out tasting off.
Second, out of the batches that I’ve done here, only two have not effected war upon my intestines a couple hours after consumption. I have an oatmeal stout that I brewed last summer still on tap because one pint is enough. I actually have served it to people I don’t like in order to get rid of it! The flavor is fine its just… (If you visit me, don’t accept my stout unless I get this figured out hahahaha)
I have my suspicions for causes but would like input from other brewers as well. I’ve read comments from folks who obviously take their brewing as serious or more so than I, and welcome any advice or thoughts!
Addressing the first issue: I’ve tried using filtered water, Pur three stage faucet filter to be precise. All water that goes into the boil as well as topping it off goes through the filter. I refuse to use straight tap water because it reeks of chlorine. My next step, which I don’t have the money for, is to go with an RO filter and rebuild the mineral makeup of the water similar to what was in Duluth. Frankly both the cost and chemistry behind that has me hesitant. I’m a bio guy, I might have minored in chem, but I don’t admit to liking it.
Another possible cause might be from letting it sit in the primary for two weeks, picking up more yeasty flavor that I want. I suppose the only way to test that is to rack right after the cap falls?
Which leads right into the second problem, which may also be caused by sitting in primary for two weeks. I just don’t buy that though.
I’ve tried using whirlfloc (sp?) tablets and that seems to have some reduction of the, ahem, side effects. One thing that I am slightly embarrassed about is a lack of using my hydrometer. Perhaps I’m not completing fermentations, but leaving the beer in secondary for nearly a month or more ought to take care of that shouldn’t it?
Any thoughts?
Cheers.